Single mouthguard, Thermoformable - Power Max Gel, Shock Doctor

Single mouthguard, Thermoformable - Power Max Gel, Shock Doctor

Gel Nano mouthguard is fully equipped with an innovative gel-fit liner and vertical wall frame. The jaw line is secured, limiting injury from side impact.

Tri-Bite stabilizers stabilize the upper and lower jaw
Upper and lower molar cushions help enhance protection and fit
Monocoque Shock Frame with vertical wall extensions shield teeth and protect the jaw against injury caused by side impacts
Gel-Fit™ Liner is the essential layer for cushion and a super-tight fit that keeps the mouthguard in place
MORA Performance enhancement, when mouthguard is fitted and worn correctly, positions the lower jaw down and forward and the tongue up onto the roof of the mouth, which may increase strength and athletic performance
Convertible tether is a quick-release tether that allows the Gel Max Flavor Fusion to be used strapped or strapless
Boil and Bite Fit requires the Gel Max Flavor Fusion mouthguard to be immersed into boiled water to be ready to start the fitting process
The Gel Nano is Latex-Free and not intended for use with braces
 

Fitting instructions :

Step 1: Fill a pan with 3 to 4 inches of water. Bring to the boil.
Step 2: Remove the water from the heat source. Let the water stand for 30 seconds, then place the mouthguard in the water for 60 seconds. Do not exceed 60 seconds.
Step 3 : Carefully remove the mouthguard from the hot water with a slotted spoon.
Step 4: Cool the mouthguard under running water for 1-2 seconds.
Step 5: Lick your lips before placing the mouthguard in your mouth.
Step 6: Align the mouthguard with the centre line of your teeth. Adjust the mouthguard over and around the upper teeth (lower teeth for Gravity 2 STC) and press firmly on the molars first, then on the front teeth.
Step 7: Close your mouth and bite down hard on the mouth guard. Aspirate strongly. Use your fingers to press the edges of the mouthguard against the teeth.
Step 8: Remove the mouthguard from the mouth and immerse it completely in the cup containing ice and cold water - allow it to cool for 2 minutes. Replace the mouthguard in the mouth and check that it fits properly.

Repeat steps 1 to 8 if the adjustment is not accurate.

Care instructions :

• Clean the mouthguard with cold water or use an antiseptic mouthwash.
• Do not use toothpaste, detergents or other cleaning products.
• Clean the mouthguard box with warm water and a small amount of antiseptic mouthwash.
• Rinse thoroughly and dry before storing the mouthguard in its box.

Shock Doctor mouthguards are manufactured in a quality controlled environment using medical grade polymers that are not known to cause allergic reactions and have no particular taste or smell.